Video Capture Revs Tilt

From BowlingChat Wiki
Jump to navigation Jump to search


- An accurate PAP marking is vital to being able to measure Axis Tilt with the Axis Tilt Axis Rotation Overlay, as is the correct camera position! If either one of those is off by a fraction of an inch it can give an inaccurate Axis Tilt measurement. I like to have a small amount of separation between the PAP tape and the tape going over the fingers as I feel it makes it easier to see that the PAP is accurately marked.


Additional Tips:
- Capture at the highest quality your camera is capable of.
- The long piece of tape should go from your PAP to above your fingers.
- Use a contrasting color tape to mark your ball, I usually use white electrical tape.
- For those who swing the ball a fair amount, it is ok to line up the camera pointing in the same direction as your ball path.
- If you have control of your cameras shutter speed set it to at least 1/100th or 1/250th to avoid motion blur.
- Motion blur can make getting an accurate measurement difficult.
- When posting online don't make the video too small or use too much compression as this will cause a loss of detail. Also pay attention to the frame rate (fps) that you save your video at, most video cameras shoot at 30fps (USA, 25fps Europe / Asia) and your video should be exported with the same frame rate.
- Loss of detail or changing frame rates can make getting an accurate measurement difficult.