Ball Layouts

The Basics

The most important thing to consider, aside from the bowler's hand measurements, is what kind of bowling ball is being drilled. There are two basic types: Symmetrical Core balls, and Asymmetrical Core balls. Most ball companies have at least a few balls of each type. Aside from the different reaction characteristics, these balls differ in how a ball driller works to lay them out.

Symmetrical Core Balls

For symmetrical core bowling balls, the three most important factors to consider in drilling the ball are the Pin placement, Center of Gravity (CG), and the bowler's Positive Axis Point (PAP). The relationship between these three things along with the ball's surface will dictate the ball's reaction on the lane.

First, the pin placement is always taken relative to the PAP. A pin that is farther away from the PAP will tend to skid much further than a ball with a pin placed closer to the PAP. Also, a Pin placed above the finger holes will tend to go longer than one placed below them. Since the Pin conrols the Track Flare, pins placed below the fingers can cause flaring over finger and/or thumb holes. Second, the CG placement is also taken relative to the PAP. It's location will dictate the Static Weights of the bowling ball. You'll often hear balls referred to as a 4 x 4 drilling, or 5 x 3, etc. This refers to these distances. The first number is the distance in inches of the Pin to the PAP, and the second is the distance of the CG to the PAP.

Asymmetrical Core Balls

For asymmetrical core bowling balls, the only factor that changes is the CG. The CG is not used in tuning the reaction of these balls, as it is for symmetrical cores. For drilling purposes asymmetrical balls are marked with a 3rd locator on the ball, for the Mass Bias (MB). The driller must use the pin location and MB location to get the desired reaction from an asymmetrical bowling ball. The same rules apply for the pin with regards to pin distance from the PAP as for symmetrical balls. Instead of the CG, the MB, which is always located 6 3/4" from the pin, must be measured in relation to the bowler's PAP. The MB is measured by degrees, as in a "45 degree Mass Bias". This implies that the MB is on a 45 degree angle from the bowler's PAP. As with Pin distance, the MB location affects the ball's reaction. A MB drilled at 90 degrees (closer to the thumb) will go much longer down the lane than a MB drilled at 0 degrees. The closer the MB is placed to the bowler's PAP, the earlier the roll and smoother the reaction, assuming that the Pin distance is the same.

Manufacturer Layouts

Asymmetric Layouts

• Brunswick Asymmetric
• Brunswick Asymmetric OLD
• Ebonite Tommy Jones Trick Layout
• Ebonite Jason Couch Trick Layout
• MoRich Asymmetrical Flip Drillings
• MoRich Standard Asymmetric Drillings
• MoRich Super Symmetric Drillings
• MoRich Double Thumb Layout
• Mo's Suggested Dual Angle Layouts for Low Track Players
• Mo's Suggested Dual Angle Layouts for Medium Track Players
• Mo's Suggested Dual Angle Layouts for High Track Players
• MoRIch RipR Tilt Based Precision Layouts

Symmetric Layouts

• Brunswick Symmetric High Diff
• Brunswick Symmetric Low Diff
• Columbia Big Hook
• Columbia Controlled Arc
• Columbia Full Roller
• Columbia Length Arc
• Columbia Length Sharp
• Ebonite Stack Leverage
• Ebonite Axis Leverage
• Ebonite Full Roller
• Ebonite High RG Arc
• Ebonite High RG Strong
• Ebonite Label Leverage
• Ebonite Low RG Arc
• Ebonite Low RG Strong
• Ebonite Medium RG Arc
• Ebonite Medium RG Strong
• Ebonite Rev Leverage
• Motiv Early
• Motiv Length
• Motiv Leverage
• Motiv Length and Leverage